 |
 |
 |
|
An open-source prototyping shield for Arduino, the ProtoShield kit has tons of cool features to make prototyping on your Arduino easy. With room for small or large breadboards for DIP chips, plus a surface-mount prototyping area too, you'll be testing all kinds of project ideas in no time. From Adafruit.
|
|
|
|
|
|
 |
|
 |
|
Features
- Nice standard 0.1"x0.1" prototying grid with big pads
- A IC pattern for adding DIP ICs up to 20 pins
- Power rails down the middle and sides
- A reset button and an extra general use button
- 2 3mm general use LEDs, red and green, as well as 2 matching resistors
- The ICSP header is up top if you like to upload to your Arduino using a programmer
- A surface-mount chip area for up to 14 SOIC size parts
- Compatible with either tiny breadboards or 'standard' breadboards with the rails removed.
- Every pin is brought out, including the new 3V and Reset header pins
- 2 0.1uF capacitors on either side for extra power stability
- Note: 3 pin female header (1x3) No longer included in kit.
|
|
|
 |
|
 |
|
|
|
