Maker SHED

Make, mod, hack, and bend your own analog noise monster! Great for beginners with it’s detailed instructions and photos of each step. Advanced users can taking advantage of the Arduino integration, control voltage in and out, or just bend it like crazy!

Choose from blue or red!

• Instructions
  Jig Sheet
  
  

The Thingamagoop has a stereo 1/8″ jack on the side to facilitate control voltage in and out. You can make your own cable very simply or order a nice, shielded one from us. It’s simply a stereo 1/8″ to two, mono female 1/4″ jacks.  Note that the CV input is not 1volt/Octave but you can use it to make some ridiculous sound!

NEW! Arduino Integration!

The Thingamagoop 2 uses Arduino to control the analog VCO as well as the LEDacle. You don’t need an Arduino board to use the Thingamagoop 2, only if you want to reprogram it. The Thingamagoop 2 circuit incorporates an AVR chip that has been programed without the Arduino bootloader. This allows the device to start up immediately but you’ll have to switch out the chip for one with the bootloader if you want to reprogram it. The programmer cable is a stereo 1/8″ cable with a ferrite noise suppressor and 3 pins on the other end that go into the Arduino headers. Not only can you directly program the Thingamgoop 2, you can communicate with it. Who will be the first to get processing to use the photocell as a variable!? Or build a midi i/o!?

Arduino Code Here