Maker SHED

The USB BUB board has been engineered to be an affordable, flexible USB connector with lots of applications. It uses the popular FT232R chip, the same as Arduinos and the FTDI cable we carry. Unassembled. Some soldering required. Add a USB Mini-B Cable for only $2 more!

• Instructions Here
  

This board has a few features not found on some other USB boards:
 * An inductor to filter some high frequency noise from the power line
* A polyfuse to protect the USB line from short circuits
* An LED which shows serial activity on both the TX and RX lines
* A shunt to switch the logic levels from 5 to 3.3 volts. This shunt doesn’t switch the power though, the 3.3 V pin from the FT232R is available but remember that it’s only good for 50 mA of current. Maybe a future version will feature a 3.3 V regulator too. If you leave the shunt off (because it sticks up say) the chip defaults to 3.3V logic levels, but these still seem to work fine on 5 volt Arduinos, BBBs etc.
* Two sets of header sockets, both of which can be remapped by the user. One pin header comes connected in the pin order of the FTDI RS232 cable (the same as the BBB/RBBB/LilyPad/Arduino Pro pin header, with the added bonus of having the DTR line instead of having to use the RTS line (with its attendant quirks), the way the FTDI cable works. The other socket is unmapped and is available for the user to remap in any convenient manner, so you basically get two adapters for the price of one. Map one for 3.3V and the other for 5V projects. Remap one for a Basic Stamp, or breadboard Arduino or anything that comes up. The main header can also be easily remapped should one wish, by cutting the traces and adding jumpers for the required pin order.