Maker SHED

So you want to get mobile with your Arduino or other micro controller, and you aren't sure where to start? This affordable 2WD robotic platform is a great start! The kit includes geared motors, wheels, and a high-strength aluminum alloy body. Just add an Arduino, or other microcontroller, motorshield, and power supply and you ready to get going!

• Connect each motor to the vertical supports using the included screws, nuts, and washers
• Attach the top and bottom plate (check orientation so it matches) by screwing on the vertical supports
• Wire the motors to your controller (not supplied)
• Mount the ball caster in the lower frame with included screws
• Screw the on/off switch and power plug into the top frame
• Wire the on/off switch and power to your micor/motor controller (not included)
• Screw the top frames to the lower frame with included screws (have built in flange)
• Connect the wheels to the motors (press fit)
• The additional metal parts are used at your discretion but are not necessary.
• Use extra parts as needed (servo, sensor mounts, etc)

2WD Mobile platform Motors: 3-6V DC
Speed: 70cm/S
Dimensions: 170mm (diameter)
Weight: 400g

Includes:
Aluminum chassis X1
wheels X4
Motors X2
Omni-directional Wheel x1



Gear Ratio 1:120
No-load speed(3V):100RPM
No-load speed(6V):200RPM
No-load current(3V):60mA
No-load current(6V):71mA
Stall current(3V):260mA
Stall current(6V):470mA
Torgue (3V): 1.2Kgcm
Torque (6V): 1.92Kgcm
Size: 55mm x 48.3mm x 23mm
Weight:45g