Geiger Counter Kit w/Acrylic Enclosure


Geiger Counter Kit  w/Acrylic Enclosure
Geiger Counter Kit  w/Acrylic Enclosure
Geiger Counter Kit  w/Acrylic Enclosure
Geiger Counter Kit  w/Acrylic Enclosure
Geiger Counter Kit  w/Acrylic Enclosure
Geiger Counter Kit  w/Acrylic Enclosure

Geiger Counter Kit w/Acrylic Enclosure

Build you own commercial Geiger kit. Test things around your kitchen for gamma rays or radiation.

Now $72.99$124.99 USD

This item is currently out of stock.

CLICK HERE to be notified when this is back in stock

Product #: MKMO3

Get a Geiger Counter Kit w/Acrylic Enclosure. Commercial Geiger counters can cost hundreds of dollars, with this Geiger Counter Kit you can build your own at a fraction of the price! This easy to solder kit can be built in an evening and it works just like you think it would; clicking and blinking in the presence of radiation. Is grandma's dish collection radioactive? Do bananas give off radiation? Are your granite table tops giving off gamma rays? After you build your own Geiger Counter you'll be able to find out! Serial logging function lets you easily track exposure over time and the mute button lets you silently detect radiation. A must for every mad scientist!


***** WARNING ***** This Geiger Counter kit is for EDUCATIONAL PURPOSES ONLY. Don't even think about using it to monitor radiation in life-threatening situations, or in any environment where you may expose yourself to dangerous levels of radiation. Don't rely on the collected data to be an accurate measure of radiation exposure! Be safe!
  • Detects Beta & Gamma Rays
  • Serial Logging Output
  • Mute Button
  • LED Indicator
  • Clicker Speaker
  • Pulse Output
  • ATtiny2313 Microcontroller
  • SBM-20 Geiger-Muller tube
  • Acrylic Enclosure Case
  • (2-AAA Alkaline Batteries Not Included
  • Usage Instructions:

    Easy, turn on the switch and listen for clicks! Watch the LED, it will flash every time a beta particle or gamma ray hits the tube! (Note: The tube that comes with the kit is not sensitive to alpha particles.) If you get tired of hearing the clicks, you can push the button S2 to MUTE the sound.

    The PULSE connector (J6) has the following pinout:
  • 1. VCC (nominally 3V)
  • 2. pulse output – a short (100us) active high pulse every time the geiger tube fires
  • 3. GND
  • Logging:

    To connect your computer to the serial port (J7), you will need a USB-serial converter that operates at 3.3V TTL levels. The serial header is set up to work with the common FTDI-232R-3V3 serial cable.

    Data is sent over the serial port at 9600 baud, 8N1.
    The data is reported in comma separated value (CSV) format: CPS, #####, CPM, #####, uSv/hr, ###.##, SLOW|FAST|INST

    There are three modes. Normally, the sample period is LONG_PERIOD (default 60 seconds). This is SLOW averaging mode. If the last five measured counts exceed a preset threshold, the sample period switches to SHORT_PERIOD seconds (default 5 seconds). This is FAST mode, and is more responsive but less accurate. Finally, if CPS > 255, we report CPS*60 and switch to INST mode, since we can’t store data in the (8-bit) sample buffer.

    The largest CPS value that can be displayed is 65535, but the largest value that can be stored in the sample buffer is 255.