Sippino USB Kit

Sippino USB Kit
Sippino USB Kit
Sippino USB Kit
Sippino USB Kit

Sippino USB Kit

SHIPS DIRECTLY FROM THE VENDOR

Eliminate dangling jumper wires and upload your sketch with a USB cable while powering your Arduino project from the same USB port.

$22.99

The Sippino USB is a member of the Sippino family that allows you to upload your sketch with a USB cable while powering your project from the same USB port.

The 'Sipp' in Sippino is from the abbreviation for "single in-line pin package". Just like the standard Sippino, all of the digital and analog pins are broken out along one edge of the PCB. This feature makes the Sippino ideal for Arduino experimenting directly on a breadboard.Since the Sippino is on the breadboard, you use fewer jumper wires, and spend less time debugging intermittent connections, or re-connecting a loose jumper in the wrong spot.

If you already have a USB to Serial adapter, or are ready to embed a Sippino into a project, you can save a few bucks by using the Sippino 328 which has the same signal pin-out. In place of the on-board FTDI chip and MicroUSB jack, the Sippino 328 has a standard FTDI pin header

Key Features

  • Small size
  • Micro USB jack
  • Breadboard friendly 0.1" breakout
  • Reset button
  • ATmega328
  • ATmega preloaded with bootloader (Duemilanove w/328)
  • RX - TX status LED
  • Includes pin header strips

 

What You'll Need

  • Micro USB Cable
  • Soldering iron, solder and flush cutters
  • Note: The surface mounts parts (FTDI chip, Micro USB connector, etc ...) come pre-soldered and tested. This is a kit and assembly is required for the through hole parts.

Product Documentation / User Guide

Instructions
FT230X Spec sheet

 

Note: This item does not qualify for discounts and only ships to US addresses.