877-306-6253

Mojo FPGA Development Board

MORE VIEWS:

Mojo FPGA Development Board
Mojo FPGA Development Board

Mojo FPGA Development Board

$74.99

VALUE ADD ONS

DETAILS

The entire goal of the Mojo is to make getting started with FPGA and digital design as simple as possible!

Product #: MKEMB01

The Mojo V3, A FPGA development board, is designed from the ground up to be easy to use.

 

The entire goal of the Mojo is to make getting started with FPGA and digital design as easy as possible. An FPGA allows you to design digital circuits. Digital circuits are basically just a bunch of logic gates (and, or, nor, etc.) connected together to perform a specific task. The designs that you create can range from something as simple as a counter to blink an LED to something as complex as a multi-core processor. FPGAs and microcontrollers, like the Arduino, are very different devices. With a microcontroller you write software. That software gives you control of the the built-in peripherals, like IO pins, serial ports, or analog to digital converters. The biggest limitation of software is that you can only do one thing at a time!

 

 

With FPGAs you are not creating software. You are designing the hardware! Instead of writing code to run on a fixed processor with fixed peripherals, you get to design your own circuit. If you really want to you can even create your very own processor and write software to run on it!

 

 

A huge benefit of working with FPGAs is that every element of your design runs independently of each other. That means one part of your design can be reading in some serial data, while another part is controlling a servo, while another is reading some sensors, and yet another is controlling a display.

 

 

With a microcontroller you can often be limited by the built in peripherals. There is a set number of serial ports, PWM pins, or maybe you can't use some components, like a camera, because you can't interface with them fast enough. With FPGAs every pin has the potential to become whatever you need it to be. Do you need 84 PWM signals to control a lot of servos? The Mojo has you covered. What about a bunch of serial ports or controlling a big LED display? You're covered there too. Since you are designing the hardware, you are deciding what each pin will do!
The Mojo V3 features:
  • Spartan 6 XC6SLX9 FPGA
  • 84 digital IO pins (3.3V logic level)
  • 8 analog inputs
  • 8 general purpose LEDs
  • 1 reset button
  • On board voltage regulation that can handle 4.8V - 12V
  • A microcontroller (ATmega32u4 used for configuring the FPGA, USB communications and reading the analog pins
  • On board flash memory to store the FPGA configuration file